Cortelco 2720 Manuel d'instructions télécharger pdf (Page 7)

Telephone Set Buttons

FLASH Button

Press the FLASH button to provide a line break to access services such as

Three-way calling, call waiting or VoiceManager features such as music on hold

and call transfer.

Steps to use with call waiting service:

1. While having a conversation, another party calls and you hear a tone.

2. Press FLASH once and release. The rst conversation is placed on hold and

the second call can be answered.

3. Press FLASH again and release. You may speak to the rst caller again and

the second call is placed on hold.

REDIAL/PAUSE Button

1. To redial one of the last 10 numbers dialed, press REDIAL. The display will

show the last number dialed. To scroll through the last 10 numbers, press

REVIEW UP or REVIEW DOWN.

2. After the desired number is selected, dial the number by pressing REDIAL

again, lifting the handset, pressing SPEAKER or pressing DIAL.

3. The selected number (32 digits maximum) will be redialed.

PAUSE

If you press the REDIAL/PAUSE button while storing a memory dial number,

it allows you to insert a 3.6-second pause in the dialing sequence. This is

particularly useful if you are connected to a PABX system where you must dial

an access code (usually the number 9) to obtain an outside line. The button

may be pressed more than once to create a longer pause.

HEADSET Button

This telephone will accept either a 2.5mm headset or an RJ-type headset

(Plantronics wireless or wired headset is recommended). Use HEADSET to

connect and disconnect from calls.

MUTE Button

Press MUTE to speak without the person on the phone hearing your

conversation. The MUTE indicator will light up and remain lighted until you

resume your conversation. Also, “MIC MUTED” will show in the display. To un-

mute the call and resume the conversation, press MUTE. The MUTE indicator

will go out and your call can continue.

1 2 3 4 5 6 7 8 9 10 11 12 ... 17 18

Pas de commentaire

Cortelco 2720 Manuel d'instructions Page 7